EasyManuals Logo

HP VSR1000 Configuration Guide

HP VSR1000
453 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
9
Ste
p
Command
Remarks
2. Configure BFD
control mode for a
static route.
• Approach 1:
ip route-static dest-address { mask | mask-length }
interface-type interface-number next-hop-address bfd
control-packet [ preference preference-value ] [ tag
tag-value ] [ description description-text ]
• Approach 2:
ip route-static vpn-instance s-vpn-instance-name&<1-6>
dest-address { mask | mask-length } interface-type
interface-number next-hop-address bfd control-packet
[ preference preference-value ] [ tag tag-value ] [ description
description-text ]
Use either
approach.
To configure BFD control mode for a static route (indirect next hop):
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Configure BFD
control mode for a
static route.
• Approach 1:
ip route-static dest-address { mask | mask-length }
{ next-hop-address bfd control-packet bfd-source ip-address
| vpn-instance d-vpn-instance-name next-hop-address bfd
control-packet bfd-source ip-address } [ preference
preference-value ] [ tag tag-value ] [ description
description-text ]
• Approach 2:
ip route-static vpn-instance s-vpn-instance-name&<1-6>
dest-address { mask | mask-length } { next-hop-address bfd
control-packet bfd-source ip-address | vpn-instance
d-vpn-instance-name next-hop-address bfd control-packet
bfd-source ip-address } [ preference preference-value ] [ tag
tag-value ] [ description description-text ]
Use either
command.
BFD echo mode
IMPORTANT:
• Enabling BFD for a flapping route could worsen the situation. Therefore, use it with caution.
• Do not use BFD for a static route with the output interface having the spoofing attribute.
With BFD echo mode enabled for a static route, the local device sends BFD echo packets to the peer,
which loops it back to test the link. For the echo mode, only one end needs to establish the BFD session,
and the source address of echo packets must be configured. To configure BFD echo mode for a static
route, you must specify both an output interface and a next hop for the static route.
To configure BFD echo mode for static routes:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A

Table of Contents

Other manuals for HP VSR1000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP VSR1000 and is the answer not in the manual?

HP VSR1000 Specifications

General IconGeneral
BrandHP
ModelVSR1000
CategoryNetwork Router
LanguageEnglish

Related product manuals