HP VSR1000 Configuration Guide

221
Step Command Remarks
4. Specify an AS number for a
peer.
peer ip-address as-number
as-number
N/A
5. Add the peer into the group.
peer ip-address group
group-name [ as-number
as-number ]
The AS number can be either
specified or not specified in the
command. If specified, the AS
number must be the same as that
specified for the peer with the peer
ip-address as-number as-number
command.
NOTE:
Peers added in the group can have different AS numbers.
To configure an EBGP peer group using Approach 3:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Create an EBGP peer group.
group group-name external N/A
4. Add a peer into the group
and specify its AS number.
peer ip-address group
group-name as-number
as-number
N/A
NOTE:
• Do not specify any AS number for a peer before adding it into the peer group.
• Peers added in the group can have different AS numbers.
Configuring BGP community
A BGP community is a group of destinations with the same characteristics. It has no geographical
boundaries and is independent of ASs.
You can configure a routing policy to define which destinations belong to a BGP community and then
advertise the COMMUNITY attribute to a peer or peer group.
You can apply a routing policy to filter routes advertised to or received from a peer or peer group
according to the COMMUNITY attribute, which helps simplify policy configuration and management.
For how to configure a routing policy, see "Configuring routing policies."
T
o configure BGP community:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A

HP VSR1000 Specifications

General

Brand	HP
Model	VSR1000
Category	Network Router
Language	English