EasyManuals Logo

HP VSR1000 Configuration Guide

HP VSR1000
453 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
24
• RFC 2453, RIP Version 2
RIP configuration task list
Task Remarks
Configuring RIP basic functions Required
Configuring RIP route
control
Configuring an additional routing metric Optional
Configuring RIPv2 route summarization Optional
Disabling host route reception Optional
Advertising a default route Optional
Configuring inbound or outbound route filtering Optional
Configuring a priority for RIP Optional
Configuring RIP route redistribution Optional
Tuning and optimizing
RIP networks
Configuring RIP timers Optional
Configuring split horizon and poison reverse Optional
Configuring the maximum number of ECMP routes
Optional
Enabling zero field check on incoming RIPv1
messages
Optional
Enabling source IP address check on incoming RIP
updates
Optional
Configuring RIPv2 message authentication Optional
Specifying a RIP neighbor Optional
Configuring RIP-to-MIB binding Optional
Configuring the RIP packet sending rate Optional
Configuring RIP FRR Optional
Configuring BFD for RIP
Single-hop echo detection mode Optional
Bidirectional control detection mode Optional
Configuring RIP basic functions
Configuration prerequisites
Before you configure RIP basic functions, complete the following tasks:
• Configure the link layer protocol.
• Configure IP addresses for interfaces, and make sure that all neighboring routers can reach each
other.
Enabling RIP and a RIP interface
Follow these guidelines when you enable RIP:

Table of Contents

Other manuals for HP VSR1000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP VSR1000 and is the answer not in the manual?

HP VSR1000 Specifications

General IconGeneral
BrandHP
ModelVSR1000
CategoryNetwork Router
LanguageEnglish

Related product manuals