HP VSR1000 Configuration Guide

262
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type interface-number N/A
3. Specify an inbound routing
additional metric.
ripng metricin value
Optional.
0 by default.
4. Specify an outbound
routing additional metric.
ripng metricout value
Optional.
1 by default.
Configuring RIPng route summarization
Ste
p
Command
1. Enter system view.
system-view
2. Enter interface view.
interface interface-type interface-number
3. Advertise a summary IPv6
prefix.
ripng summary-address ipv6-address prefix-length
Advertising a default route
With this feature enabled, a default route is advertised through the specified interface regardless of
whether the default route is available in the local IPv6 routing table.
To advertise a default route:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Advertise a default route.
ripng default-route { only |
originate } [ cost cost ]
Not advertised by default.
Configuring a RIPng route filtering policy
Reference a configured IPv6 ACL or prefix list to filter received or advertised routing information. You can
also filter outbound routes redistributed from a routing specific routing protocol.
To configure a RIPng route filtering policy:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RIPng view.
ripng [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Configure a filter policy to
filter incoming routes.
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }
import
By default, RIPng does not filter
incoming routing information.

HP VSR1000 Specifications

General

Brand	HP
Model	VSR1000
Category	Network Router
Language	English