HP VSR1000 Configuration Guide

366
Ste
p
Command Remarks
6. Set a cost for routing
information.
apply cost [ + | - ] value
Optional.
Not set by default.
7. Set a cost type for routing
information.
apply cost-type [ external | internal
| type-1 | type-2 ]
Optional.
Not set by default.
8. Set the extended community
attribute for BGP routing.
apply extcommunity { rt
route-target }&<1-16> [ additive ]
Optional.
Not set by default.
9. Set the next hop.
• Set the next hop for IPv4 routes:
apply ip-address next-hop
ip-address
• Set the next hop for IPv6 routes:
apply ipv6 next-hop
ipv6-address
Optional.
Not set by default.
The setting does not apply to
redistributed routing information.
The apply ip-address next-hop
and apply ipv6 next-hop
commands do not apply to
redistributed IPv4 and IPv6
routes.
10. Inject routing information to a
specified ISIS level.
apply isis { level-1 | level-1-2 |
level-2 }
Optional.
Not configured by default.
11. Set the local preference for
BGP routing information.
apply local-preference preference
Optional.
Not set by default.
12. Set the ORIGIN attribute for
BGP routing information.
apply origin { egp as-number | igp
| incomplete }
Optional.
Not set by default.
13. Set the preference for the
routing protocol.
apply preference preference
Optional.
Not set by default.
14. Set a preferred value for BGP
routing information.
apply preferred-value
preferred-value
Optional.
Not set by default.
15. Set a tag value for RIP, OSPF, or
IS-IS routing information.
apply tag value
Optional.
Not set by default.
16. Configure FRR.
apply fast-reroute
{ backup-interface interface-type
interface-number [ backup-nexthop
ip-address ] }
Optional.
Not configured by default.
The difference between IPv4 and IPv6 apply clauses is the command for setting the next hop for routing
information.
Defining a continue clause
Follow these guidelines when you define a continue clause:
• If you configure the same type of apply clauses that set different values (including the apply
community and apply extcommunity clauses with the additive keyword) on nodes that are
combined by the continue clause, the apply clause configured on the last matching node takes
effect.

HP VSR1000 Specifications

General

Model	VSR1000
Category	Network Router
Product Type	Router
Manufacturer	HP
Series	VSR
Form Factor	Rack-mountable
IPSec VPN Throughput	200 Mbps
Virtualization Support	Yes
Maximum Throughput	1 Gbps
Routing Protocols	OSPF, BGP
Virtualization Platforms	VMware
Management	Web-based management, CLI
Remote Management Protocol	SNMP, SSH, Telnet
Encryption	AES, 3DES
VPN Support	IPSec
Firewall Protection	Stateful packet inspection