HP VSR1000 Configuration Guide

142
Ste
p
Command Remarks
5. Enter interface view.
interface interface-type
interface-number
N/A
6. Enable an IS-IS process on the
interface.
isis enable [ process-id ] Disabled by default.
Configuring the IS level and circuit level
If only one area is available, HP recommends you to perform the following operations:
• Configure the IS level of all routers as Level-1 or Level-2 rather than different levels because the
routers do not need to maintain two identical LSDBs.
• Configure the IS level as Level-2 on all routers in an IP network for scalability.
For an interface of a Level-1 (or Level-2) router, the circuit level can only be Level-1 (or Level-2). For an
interface of a Level-1-2 router, the default circuit level is Level-1-2; if the router only needs to form Level-1 (or
Level-2) neighbor relationships, then configure the circuit level for its interfaces as Level-1 (or Level-2) to
limit neighbor relationship establishment.
To configure the IS level and circuit level:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter IS-IS view.
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Specify the IS level.
is-level { level-1 | level-1-2 |
level-2 }
Optional.
The default is Level-1-2.
4. Return to system view.
quit N/A
5. Enter interface view.
interface interface-type
interface-number
N/A
6. Specify the circuit level.
isis circuit-level [ level-1 | level-1-2
| level-2 ]
Optional.
By default, an interface can establish
the Level-1 or Level-2 adjacency.
Configuring the network type of an interface as P2P
Perform this task only for a broadcast network that has up to two attached routers.
Interfaces with different network types operate differently. For example, broadcast interfaces on a
network must elect the DIS and flood CSNP packets to synchronize the LSDBs, but P2P interfaces on a
network do not need to elect the DIS, and have a different LSDB synchronization mechanism.
If only two routers exist on a broadcast network, configure the network type of attached interfaces as P2P
to avoid DIS election and CSNP flooding, saving network bandwidth and speeding up network
convergence.
To configure the network type of an interface:

HP VSR1000 Specifications

General

Brand	HP
Model	VSR1000
Category	Network Router
Language	English