HP VSR1000 Configuration Guide

255
Ste
p
Command Remarks
2. Configure an IPv6 static route.
• Approach 1:
ipv6 route-static ipv6-address prefix-length
{ interface-type interface-number
[ next-hop-address ] | next-hop-address |
vpn-instance d-vpn-instance-name
nexthop-address } [ preference
preference-value ]
• Approach 2:
ipv6 route-static vpn-instance
s-vpn-instance-name&<1-6> ipv6-address
prefix-length { interface-type
interface-number [ next-hop-address ] |
nexthop-address [ public ] | vpn-instance
d-vpn-instance-name nexthop-address }
[ preference preference-value ]
Use either approach.
The default
preference of IPv6
static routes is 60.
NOTE:
If you specify a broadcast interface, such as an Ethernet interface or a VLAN interface, as the output
interface for a static route, you must specify the next hop address.
Displaying and maintaining IPv6 static routes
Task Command Remarks
Display IPv6 static route
information.
display ipv6 routing-table protocol
static [ inactive | verbose ] [ |
{ begin | exclude | include }
regular-expression ]
Available in any view
Remove all IPv6 static routes.
delete ipv6 [ vpn-instance
vpn-instance-name ] static-routes
all
Available in system view
To delete a single IPv6 static route, use the undo ipv6 route-static command. To delete all IPv6 static
routes, including the default route, use the delete ipv6 static-routes all command.
For more information about the display ipv6 routing-table protocol static [ inactive | verbose ] [ | { begin
| exclude | include } regular-expression ] command, see Layer 3—IP Routing Command Reference.
IPv6 static routing configuration example
Network requirements
As shown in Figure 98, configure IPv6 static routes so that hosts can reach one another.

HP VSR1000 Specifications

General

Brand	HP
Model	VSR1000
Category	Network Router
Language	English