HP VSR1000 Configuration Guide

159
Enabling IS-IS SNMP trap
This task enables IS-IS to generate traps and send them to the information center of the device. The
information center determines whether to output the traps and where to output. For more information
about information center, see Network Management and Monitoring Configuration Guide.
To enable IS-IS SNMP trap:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter IS-IS view.
isis [ process-id ] [ vpn-instance vpn-instance-name ] N/A
3. Enable SNMP trap.
is-snmp-traps enable Enabled by default
Binding an IS-IS process with MIBs
This task allows you to bind MIB with an IS-IS process to send and collect information. For more
information about MIB, see Network Management and Monitoring Configuration Guide.
To bind an IS-IS process with MIBs:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter IS-IS view.
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Bind the IS-IS process with
MIBs.
isis mib-binding process-id
By default, MIBs are bound with
IS-IS process 1.
Configuring BFD for IS-IS
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type interface-number N/A
3. Enable IS-IS on the interface.
isis enable [ process-id ] Disabled by default.
4. Enable BFD on the IS-IS
interface.
isis bfd enable Not enabled by default.
Displaying and maintaining IS-IS

HP VSR1000 Specifications

General

Brand	HP
Model	VSR1000
Category	Network Router
Language	English