HP VSR1000 Configuration Guide

31
Ste
p
Command Remarks
4. Redistribute routes from
another protocol.
import-route protocol [ process-id
| all-processes | allow-ibgp ] [ cost
cost | route-policy
route-policy-name | tag tag ] *
By default, no redistribution is
configured.
Tuning and optimizing RIP networks
Before you tune and optimize RIP networks, complete the following tasks:
• Configure IP addresses for interfaces, and make sure that all neighboring nodes can reach each
other.
• Configure RIP basic functions.
Configuring RIP timers
You can change the RIP network convergence speed by adjusting RIP timers. Based on network
performance, make RIP timers of RIP routers identical to each other to avoid unnecessary traffic or route
oscillation.
To configure RIP timers:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Configure values for RIP
timers.
timers { garbage-collect
garbage-collect-value | suppress
suppress-value | timeout
timeout-value | update
update-value } *
Optional.
The default update timer, timeout
timer, suppress timer, and
garbage-collect timer are 30s,
180s, 120s, and 120s
respectively.
Configuring split horizon and poison reverse
The split horizon and poison reverse functions can avoid routing loops. If both split horizon and poison
reverse are configured, only the poison reverse function takes effect.
Enabling split horizon
The split horizon function disables an interface from sending routes received from the interface to prevent
routing loops between adjacent routers.
To enable split horizon:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A

HP VSR1000 Specifications

General

Brand	HP
Model	VSR1000
Category	Network Router
Language	English