HP VSR1000 Configuration Guide

151
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Specify the minimum interval
for sending LSPs and the
maximum LSP number that
can be sent at a time.
isis timer lsp time [ count count ]
Optional.
By default, the minimum interval is 33
milliseconds, and the maximum LSP
number that can be sent at a time is 5.
4. Specify the LSP retransmission
interval on a P2P link.
isis timer retransmit seconds
Optional.
5 seconds by default.
Configure a proper LSP retransmission
interval to avoid unnecessary
retransmissions.
Specifying LSP lengths
IS-IS messages cannot be fragmented at the IP layer because they are directly encapsulated in frames.
IS-IS routers in an area must send LSPs smaller than the smallest interface MTU in this area.
If the IS-IS routers have different interface MTUs, HP recommends configuring the maximum size of
generated LSP packets to be smaller than the smallest interface MTU in this area. If they are not, the
routers must dynamically adjust the LSP packet size to fit the smallest interface MTU, which takes time and
affects other services.
To specify LSP lengths:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter IS-IS view.
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Specify the maximum length
of generated Level-1 LSPs or
Level-2 LSPs.
lsp-length originate size [ level-1 | level-2 ] 1497 bytes by default.
4. Specify the maximum length
of received LSPs.
lsp-length receive size 1497 bytes by default.
Enabling LSP flash flooding
Changed LSPs may trigger SPF recalculation, so you can enable LSP flash flooding to advertise the
changed LSPs before the router recalculates routes. Doing so can speed up network convergence.
To enable LSP flash flooding:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter IS-IS view.
isis [ process-id ] [ vpn-instance vpn-instance-name ] N/A
3. Enable LSP flash
flooding.
flash-flood [ flood-count flooding-count |
max-timer-interval flooding-interval | [ level-1 |
level-2 ] ] *
Not enabled by
default.

HP VSR1000 Specifications

General

Brand	HP
Model	VSR1000
Category	Network Router
Language	English