434
NextHop : ::1 Preference: 0
Interface : InLoop0 Cost : 0
Destination: 30::/64 Protocol : Direct
NextHop : 30::2 Preference: 0
Interface : Vlan30 Cost : 0
Destination: 30::2/128 Protocol : Direct
NextHop : ::1 Preference: 0
Interface : InLoop0 Cost : 0
Destination: 2012:1::/64 Protocol : OSPFv3
NextHop : FE80::202:FF:FE02:2 Preference: 150
Interface : Vlan30 Cost : 1
Destination: FE80::/10 Protocol : Direct
NextHop : :: Preference: 0
Interface : NULL0 Cost : 0
The output shows that PE 1 has learned the private route of VPN 1 through OSPFv3.
Take similar procedures to configure OSPFv3 process 20 between the MCE and PE 1 and
redistribute VPN 2's routes from RIPng process 20 into the OSPFv3 routing table of the MCE. The
following output shows that PE 1 has learned the private route of VPN 2 through OSPFv3.
[PE1] display ipv6 routing-table vpn-instance vpn2
Routing Table : vpn2
Destinations : 5 Routes : 5
Destination: ::1/128 Protocol : Direct
NextHop : ::1 Preference: 0
Interface : InLoop0 Cost : 0
Destination: 40::/64 Protocol : Direct
NextHop : 40::2 Preference: 0
Interface : Vlan40 Cost : 0
Destination: 40::2/128 Protocol : Direct
NextHop : ::1 Preference: 0
Interface : InLoop0 Cost : 0
Destination: 2012::/64 Protocol : OSPFv3
NextHop : FE80::200:FF:FE0F:5 Preference: 150
Interface : Vlan40 Cost : 1
Destination: FE80::/10 Protocol : Direct
NextHop : :: Preference: 0
Interface : NULL0 Cost : 0
Now, the routing information of the two VPNs has been added into the routing tables on PE 1.
To Next Page
Loading...
Need help?
General
