HPE FlexNetwork MSR Series - E1;T1 Interface Module

7
NOTE:
The
SIC-1GEC-V2/SIC-1GEC-H3 provides an interface that combines a fiber port and a copper
port.
Only one port of the combo interface can be activated
at a time. The copper port is activated by
default. To use the fiber port, execute the related command at the command line interface (CLI).
Interface LEDs
Figure 10 SIC-1GEC-H3 panel
Figure 11 SIC-1GEC-V2 panel
Table 13 LED description for the SIC-1GEC-V2/SIC-1GEC-H3
LED
Description
LINK
• On means carrier signal is received.
• Off means no carrier signal is received.
• Green: Data is being received and transmitted at a speed of 1000 Mbps.
• Yellow: Data is being received and transmitted at a speed of 100/10 Mbps.
ACT
• Off: No data is being received and transmitted.
• Flashing: Data is being received and transmitted.
Table 14 LED description for the SIC-1GEC-V2/SIC-1GEC-H3
LED
Description
LINK
• On means carrier signal is received.
• Off means no carrier signal is received.
• Green: Data is being received and transmitted at a speed of 1000 Mbps.
• Yellow: The module is faulty.
ACT
• Off: No data is being received and transmitted.
• Flashing: Data is being received and transmitted.
Interface cables and connection methods
For more information about the Ethernet interface cables and connection methods, see "Ethernet
interface."
For more information about fiber ports, optical fibers, and the connection methods, see "Fiber port."
E1/T1 interface module
• SIC-1E1-F
• SIC-2E1-F
• SIC-EPRI