HPE FlexNetwork MSR Series - MIM-1 Vt1

74
LED
Description
LP/AL
• On means the interface is in a loopback.
• Flashing means an AIS, LFA, or RAI alarm signal is present.
• Off means no loopback or alarm is present.
Note:
AIS = Alarm indication signal; LFA = loss of frame alignment; RAI = Remote alarm indication
Interface cables and connection methods
For more information about E1 interface cables, see "E1 interface."
MIM-1VT1
Introduction
The 1-port T1 voice interface module (MIM-1VT1) handles dense voice signals in the VoIP system.
The MIM-1VT1 module is structured in the form of board plus VCPM module plus VPM strip. It
provides a CT1/PRI port that allows access of 24 channels of voice signals.
Interface specifications
Table 117 Interface specifications
Item
Specification
Connector RJ-45
Number of connector 1
Interface standard
• G.703/T1.102
• G.704
• AT&T TR 54016
• AT&T TR 62411
• ANSI T1.403
Interface rate 1.544 Mbps
Cable type T1 cable (100-ohm standard shielded cable)
Operating mode
CT1
ISDN PRI
Services
Backup
Terminal access
ISDN
Interface LEDs
Figure 83 MIM-1VT1 panel