HPE FlexNetwork MSR Series - Page 49

43
Item
Specification
Interface standard
• TNC: LTE, UMTS, HSPA+, CDMA 1x, EVDO Release 0 & A, Quad-band EDGE,
GPRS, and GSM.
• SMA: GPS.
• Mini USB Type AB: Support for USB devices.
Cable type
• TNC: None
• SMA: Flexible 174 sized cable
• Mini USB Type AB: USB console cable
Services
• LTE.
• UMTS.
• HSPA+.
• Quad-band EDGE.
• GPRS.
• GSM.
• GPS.
Interface LEDs
Figure 44 SIC-4G-LTE-G (JG744A) panel
Table 68 LED description
LED
Description
WWAN
• Steady green: A link is present.
• Flashing green fast: Data is being transmitted or received.
• Flashing green slowly: The module is searching for 4G WLANs.
• Off: No link is present.
RSSI
• Steady green: Strong signal strength. The RSSI is equal to or greater than
–69 dBm.
• Flashing green fast: Middle- or low-level signal strength. The RSSI is equal
to or greater than –89 dBm and less than –69 dBm.
• Flashing green slowly: Low signal strength. The RSSI is equal to or greater
than –99 dBm and less than –89d Bm.
• Off: Weak or no signal strength. The RSSI is less than –99 dBm.
HSPA+
• Steady green: The HSPA+ or HSDPA service is valid.
• Off: The HSPA+ or HSDPA service is not available.
LTE
• Steady green: The LTE service is valid.
• Off: The LTE service is not available.
GPS
• Steady green: The GPS service is valid.
• Off: The GPS service is not available.
Connecting the antenna and interface cables
For more information about connecting antennas and interface cables for the interface module, see
"4G interface."