HPE ProLiant Gen9

Action
1. Identify the drives that contain the lost logical volumes.
2. Do one of the following:
• Move the drives to another controller where the logical volumes can be recreated.
• If a drive contains a valid logical volume that is in use and a lost logical volume, then do not move that
drive to another controller.
Controller State: The array controller contains one or more logical drives with a RAID level
that is not supported in the current configuration
Symptom
Controller State: The array controller contains one or more logical drives with a RAID level that is not
supported in the current configuration. Any configuration command (e.g. logical drive creation, array
expansion, etc.) or modification to the controller will result in the loss of all existing data on the disabled
volume(s).
Solution 1
Cause
The configuration requires more drives than are currently supported.
Action
1. If this message is observed after moving a configured array of drives from another controller, do the
following:
a. Upgrade the firmware on this controller.
b. Make sure that the cache module is installed. Install the cache module if not present.
c. If the issue persists, power down the and move the drives back to the original controller.
Solution 2
Action
1. If this message is observed without any drive movement, do the following:
a. Make sure that the cache module is working.
b. Replace the cache module, if required.
Controller State: The array controller contains one or more logical drives with
a RAID level that is not supported in the current configuration 13