HPE ProLiant Gen9

Module reason code Description
vcEnetmoduleModuleMissing A configured module has been removed.
vcEnetmodulePortprotect A condition has been detected on the port causing
port protection to be activated.
vcEnetmoduleIncompatible The module is incompatible, for example, a
configured Enet module is replaced with an FC
module.
vcEnetmoduleHwDegraded The module is being reported as degraded by the
OA.
vcEnetmoduleUnknown The condition of the module is unknown.
vcFcmoduleOk The FC module is functioning normally.
vcFcmoduleEnclosureDown The FC module is unable to communicate with the
enclosure/OA.
vcFcmoduleModuleMissing A configured module has been removed.
vcFcmoduleHwDegraded The module is reporting a degraded hardware
condition.
vcFcmoduleIncompatible The module is incompatible, such as replacing a
configured FC module with an Enet module.
vcFcmoduleUnknown The condition of the module is unknown.
vcPhysicalServerManagedStatusChanged
The following is an example of a physical server Cause string:
Server enc0:dev1 unable to communicate with enclosure enc0
The following is an example of a physical server RootCause string:
Server enc0:dev2 profile pending
The physical server managed status ReasonCodes are provided in the following table.
Physical server reason code Description
vcPhysicalServerOk The server is functioning normally.
vcPhysicalServerEnclosureDown The server is unable to communicate with the
enclosure/OA.
vcPhysicalServerFailed The server is in a failed condition.
vcPhysicalServerDegraded The server is in a degraded condition.
vcPhysicalServerUnknown The condition of the server is unknown.
vcFcFabricManagedStatusChanged
The following is an example of an FC fabric Cause string:
1 of 2 uplink ports are abnormal on BackupSAN fabric
The following is an example of an FC fabric RootCause string:
1 of 2 uplink ports are abnormal on BackupSAN fabric
The FC fabric managed status ReasonCodes are provided in the following table.
HPE Virtual Connect errors 281