Huawei NetCol8000-A045D - Installing Cooling Water Pipes for the Water Cooling Module; Optional) Connecting the Humidifier Water Inlet Pipe

4.8.6 Installing Cooling Water pipes for the Water Cooling
Module
Prerequisites
Clean the water inlet engineering pipes to avoid impurities entering into the water
cooling module.
Procedure
Step 1 Remove the plugs from the water pipes.
Step 2 Apply thread sealant.
Step 3 Connect water pipes by using a wrench. The connector is G1-1/2 inch with internal
screw threads.
Figure 4-71 Connecting water pipes
----End
4.8.7 (Optional) Connecting the
Humidier Water Inlet Pipe
Context
● A reducing valve must be installed if the inlet water pressure exceeds 0.7 MPa.
● Appliance is intended to be permanently connected to the water mains and
not connected by a hose-set.
Procedure
Step 1 Install the adapter of the
humidier inlet water pipe. Sealing washer is
recommended.
NetCol8000-A(045, 055, 060, 090, 120) In-room Air
Cooled Smart Cooling Product
User Manual 4 System Installation
Issue 05 (2020-10-10) Copyright © Huawei Technologies Co., Ltd. 110