Huawei NetCol8000-A045D - Replacing a Wet Film Humidifier

Figure 11-6 Removing the fan drive (downow, NetCol8000-A060D used as an
example)
Step 4
Pull out the handle and remove the fan drive from the subrack, as shown by 2 in
Figure 11-5 or Figure 11-6.
Step 5 Install a new fan drive, insert it into the corresponding slot, and ip the buckle
downwards to lock the module.
Step 6 Turn on the smart cooling product switch in the PDF.
Step 7 Switch on the QF1 and QF2, and close the front door.
Step 8 After the home screen is displayed, check that the smart cooling product is
running properly and no alarm is generated.
----End
11.5 Replacing a Wet Film Humidier
Prerequisites
● A wet lm humidier needs to be replaced.
● A spare
humidier pump of the same model is available and functional.
Procedure
Step 1 Tap Shutdown on the home screen and turn o the smart cooling product switch
in the PDF.
NO TICE
Exercise caution because the device is still energized after it is shut down on the
home screen.
NetCol8000-A(045, 055, 060, 090, 120) In-room Air
Cooled Smart Cooling Product
User Manual 11 Parts Replacement
Issue 05 (2020-10-10) Copyright © Huawei Technologies Co., Ltd. 262