● Teamwork group No.: Group the units in same aisle or adjacent areas as one,
that is, assign one teamwork group number for them. At most four teamwork
groups can be assigned (1–4).
● System address: The address (congurable range: 1–32) of each unit in the
same group must be unique. The unit with the smallest unit address is the
master unit, which collects, processes, and delivers group data.
Context
The parameters in this section are for reference only. Set practical parameter
values as required.
Procedure
Step 1 On the home screen, tap
> Teamwork Settings to enter the Teamwork
Settings screen.
Figure 6-20 Teamwork Settings
Step 2 Set teamwork parameters.
All teamwork control parameters can be set on the master unit. Only Teamwork
group No., System address, Enable teamwork CAN resistor, Teamwork
function, and Networking mode can be set on slave units. Other parameters of
the slave units will be
modied by the master unit synchronously.
Parameter
Description
Teamwork group No. Species the planned teamwork group number. This
parameter should be the same for all units in the
same teamwork group.
System address Species the planned teamwork group number. This
parameter should be the same for all units in the
same teamwork group.
Networking mode Species the networking mode for teamwork control.
The networking mode selected on the screen must
match the actual networking mode. Otherwise, the
teamwork function is unavailable.
Teamwork function Species the planned teamwork group number. This
parameter should be the same for all units in the
same teamwork group.
NetCol8000-A(045, 055, 060, 090, 120) In-room Air
Cooled Smart Cooling Product
User Manual 6 Power-On Commissioning
Issue 05 (2020-10-10) Copyright © Huawei Technologies Co., Ltd. 183
To Next Page
Loading...
