Hypertherm ArcGlide Torch Height Control User Manual

4-40 ArcGlide THC Instruction Manual
MAINTENANCE
Error Description Possible Causes Corrective action
36
The number of Hypernet
packets that dropped out
exceeded the maximum
number.
The Hypernet components
are not addressed
properly.
The Ethernet cable is loose
or damaged.
Check the unit addresses on all the Hypernet devices
and verify that all units on each station have the same
unit address.
Check all Ethernet cable connections.
Check all Ethernet cables for damage.
2

Hypertherm ArcGlide Torch Height Control Specifications

General

Brand	Hypertherm
Model	ArcGlide Torch Height Control
Category	Cutter
Language	English