ArcGlide THC Instruction Manual 2-3
INSTALLATION
Hardware setup
Upon receipt
• Verify that all system components on your order have been received. Contact your supplier if any items aremissing.
• Inspect the system components for any physical damage that may have occurred during shipping. If there is evidence
of damage, refer to Claims. All communications regarding claims must include the model number and serial number
located on the back of the unit.
Claims
Claims for damage during shipment – If your unit was damaged during shipment, you must le a claim with the
carrier. Hypertherm will furnish you with a copy of the bill of lading upon request. If you need additional assistance, call
Customer Service listed in the front of this manual, or your authorized Hypertherm distributor.
Claims for defective or missing merchandise – If any of the merchandise is defective or missing, contact your
supplier. If you need additional assistance, call Customer Service listed in the front of this manual, or your authorized
Hypertherm distributor.
Installation requirements
All installation and service of the electrical and plumbing systems must conform to national and local
electrical and plumbing codes. This work should be performed only by qualified, licensed personnel.
Direct any technical questions to the nearest Hypertherm Technical Service Department listed in the front of this manual,
or your authorized Hypertherm distributor.
Placement of system components
• Place all system components in position prior to making electrical and interface connections. Use the diagram in this
section for component-placement guidelines.
• Ground all system components to earth. See Recommended grounding and shielding practices in this section for
details.
To Next Page
Loading...
Need help?
General
