Service Procedures for the Cover, Panels, and Connectors
66 810440 Service Parts and Procedures Powermax65/85 SYNC
11 . If you have a machine interface receptacle, install the 2 mounting screws that attach the
machine interface receptacle to the rear panel. Tighten the screws to 1.1 Nm (10 lbfin).
12. Install the air filter assembly and gas inlet fitting. Refer to page 84.
13. Attach the rear panel. Refer to page 58.
14. Install the plasma power supply cover and the component barrier. Refer to page 51.
To Next Page
Loading...
