How To Print the Program Setup Configuration
1. Power on (|) the printer.
2. Load forms.
3. Press the Menu/Enter key.
4. The printer goes off-line, and the message PRINT OUT=NO displays.
5. To print the settings, press the Pitch key. The message PRINT OUT=YES displays, and the Program Setup
Printout is printed.
How To Run the Test and Diagnostic (T&D) Programs
The T&D program can be run in two modes, Single Test Mode or Automatic Test Mode. The Single Test Mode is
used to run individual tests; for example, to perform an adjustment or print a print test. The Automatic Test Mode,
which runs all the tests sequentially, is used to verify that the printer operates correctly.
1. Power off (O) the printer.
2. Remove all paper from the paper paths. Tests T&D11 through T&D18, and T&D21 can perform paper path
sensor, and tuning. If sensors are tuned with paper in the path, paper will not feed correctly.
3. If a stacker assembly is installed, disconnect the ASF connector, and remove the ASF stacker assembly.
Note: The following 3 steps refer to loop-back connectors needed for T&D06, 09, and 10. If the connectors
are not available, the tests can be bypassed as described in “T&D Descriptions” on page 164.
Attention: Power off (O) the printer before installing or removing the parallel or stacker/ASF options loop-back
connectors.
4. If you are here to run T&D in Automatic Mode or to run T&D6 (Parallel Attachment Test) in Single Mode, a
loop-back connector needs to be installed. Install the parallel loop-back connector (PN 08H7269) on the
attachment bezel.
5. If you are here to run T&D in Automatic Mode or to run T&D9 (Serial Attachment Test) in Single Mode, a
loop-back connector needs to be installed. Install the serial RS-232 (PN 08H7268) connector on the
attachment bezel. You will be prompted by the display to install the RS-422 (PN 08H7259) connector during
the test.
6. If you are here to run T&D in Automatic Mode or to run T&D10 (Stacker/ASF Test), a loop-back connector
needs to be installed. Install the stacker/ASF loop-back connector (PN 08H7270) on the stacker connector.
Chapter 2. Diagnostics 161
To Next Page
Loading...
Need help?
General