Ribbon Drive Motor
CAUTION:
The ribbon motor may be hot. Wait for it to cool down.
Removal
1. Remove the printer covers. See “Printer Covers” on page 347.
2. Remove the ribbon. See “Ribbon” on page 353.
3. Disconnect the ribbon motor cable connector from the logic board. Note the location of the connector and the
cable path to aid installation.
Note: If the motor is being removed only to access other parts, do not disconnect the connector.
Figure 133. Ribbon Drive Motor Connector - Model A00 Early-Level
Chapter 5. Removals and Adjustments 403
To Next Page
Loading...
