Replacement
1. Follow the removal steps in reverse order.
Attention: Ensure that cables do not rub on paper feed belt.
2. Perform the paper feed belt tension service check. See “Paper Feed Belt” on page 281.
Lower Plastic Shield/Support Assembly
Before You Begin
Determine whether your printer has a one-piece or two-piece version. If the support assembly has 2 screws (see
Figure 188 on page 452), the printer contains a two-piece version; if the support assembly does not have 2
screws, the printer contains a one-piece version.
Screws
Figure 187. Paper Feed Belt Tension Lever Screws.
(Viewed From Right Side)
Chapter 5. Removals and Adjustments 451
To Next Page
Loading...
