Printer Mechanical Assembly
Removal
DANGER
To prevent serious personal injury from electrical shock when connecting or disconnecting the interface
cable, set the printer power switch to O (Off) and unplug the power cord.
DANGER
Do not connect or disconnect any communication port, teleport, attachment connector, or power cord
during an electrical storm.
1. Remove the printer covers.
2. Remove any attachment cards.
3. Remove the logic board.
For Model A00, see page “Logic Board - Model A00” on page 370.
For Models 001 and 002, see page “Logic Board - Models 001 and 002” on page 378. Or “Logic Board -
Model 003” on page 366.
4. Disconnect the carriage motor fan connector from the power supply.
Chapter 5. Removals and Adjustments 444
To Next Page
Loading...
