Attachment Card Procedure 1
Models 001 and 002 connect to a host by using one of the following features:
v Coax IPDS attachment
v Coax SCS attachment
v Twinax IPDS attachment
v Twinax SCS attachment
Proper operation of the feature requires the correct combination of attachment card
and
microcode modules on
the attachment card and logic board.
DANGER
To prevent serious personal injury from electrical shock when connecting or disconnecting the interface
cable, set the printer power switch to O (Off) and unplug the power cable.
DANGER
Do not connect or disconnect any communication port, teleport, attachment connector, or power cord
during an electrical storm.
v Power off (O) the printer.
v Unplug the printer and disconnect the cable.
v Remove the attachment card. See “Coax Attachment Card - Models 001, and 002” on page 392 or “Twinax
Attachment Card - Models 001, and 002” on page 396.
Chapter 1. Diagnosing Problems 50
To Next Page
Loading...
Need help?
General