Model A00 Configuration Information
This section provides configuration information for the Model A00 printer. There are two sections:
1. Power-on configuration, see “Power On Configuration Menu”.
2. Program configuration, see “Program Configuration Menu” on page 492.
Power On Configuration Menu
How To Print the Power On Configuration:
1. Load forms.
2. Power off (O) the printer.
3. Press and hold the Menu/Enter key while powering on the printer.
4. Hold the Menu/Enter key pressed until the printer has stopped all motion (approximately 20 seconds).
5. Release the Menu/Enter key and the message PRINT OUT=NO will display.
6. To print the current settings, press the Pitch key. The message PRINT OUT=YES will display and the
Configuration Printout is printed.
Power On Configuration Printout - Sample Printout Showing Factory Defaults:
Figure 194 on page 486
shows the factory default settings for the Power On Configuration for a Model A00 printer.
Appendix A. Printer Configuration 485
To Next Page
Loading...
Need help?
General