T&D Descriptions
1. If an error message is displayed during the T&D program, note the error information.
TD XX FRU X (X)
2. Press any of the keys.
3. The following message will display:
REPT SKIP INIT
4. To repeat the last test, press the Micro ↑ key to select REPT.
5. To skip to the next test, press the Micro ↓ key to select SKIP.
6. To restart the T&D program from the beginning, press the Load/Form Feed key to select INIT.
7. For error code descriptions and repair action, go to “T&D Error Messages and Actions” on page 190.
T&D01 - Microcode Test
Display:
T&D 01 USER
If an error message is displayed, go to “T&D Error Messages and Actions” on page 190. The test completed
successfully if the display advances to the next
T&D02 - Microcode Test
Display:
T&D 02 CRC ROM *
Note: The asterisk will flash during the test.
If an error message is displayed, go to “T&D Error Messages and Actions” on page 190. The test completed
successfully if the display advances to the next test number.
Chapter 2. Diagnostics 164
To Next Page
Loading...
