Important
In the next step, ensure you do not power off the printer when removing the left side cover to look at
the platen pinch-roller gear.
3. Remove the left side-cover and look at the platen pinch roller gear on the left side to determine if the rollers
are closed (touching platen) or open (not touching platen).
4. Press the Micro ↓ key to get the next display:
Y CHANGE IT? N
5. Compare the position of the gear with the display in step 1 of this T&D, and perform the action requested in
the following table:
Gear Display Action
Closed PINCH CLOSE Press the
Load/Form Feed
key
e90atd1
Figure 14. Pinch Roller Gear.
(Viewed From Left Side)
Chapter 2. Diagnostics 169
To Next Page
Loading...
Need help?
General