9. The following message will be displayed.
.....TEST AND DIAGNOSTIC STARTUP...... SINGLE YES ... NO
If the T&D does not run
If the operator panel displays the message:
ATTACHMENT CARD IS NOT COMPATIBLE
WITH THE PRINTER BASE CODE
The problem is that you do not have a coax attachment card installed with the coax base code. Install
either an appropriate attachment card, or coax base code.
If the operator panel displays the message:
WAITING CODE DOWNLOAD
You have accidentally pressed the Start and Cancel keys instead of the Stop and Test keys.
10. To run all the tests sequentially, go to Automatic Test Mode step 12 on page 203.
To run specific tests, go to the Single Test Mode in the next step.
11. Single Test Mode:
Note: This program allows forward scrolling only.
.....TEST AND DIAGNOSTIC STARTUP...... SINGLE YES ... NO
a. Press the Line Feed key to select YES. The following message will be displayed:
T&DXX Microcode Test RUN TEST ? YES END NO
b. To scroll to the desired test, press the Start (NO) key.
Chapter 2. Diagnostics 202
To Next Page
Loading...
Need help?
General