Table 28. T&D Error Messages and Actions (continued)
Error Message Description Action
TD 38 FRU 7 38 Attachment Card
BCP Analog Failure
Replace the attachment card.
See “Coax Attachment Card - Models 001, and 002” on
page 392. For Model 003, see “Model 003 Attachment
Cards: Serial, Twinax, LAN, Coax” on page 359.
See “Twinax Attachment Card - Models 001, and 002”
on page 396. For Model 003, see “Model 003
Attachment Cards: Serial, Twinax, LAN, Coax” on
page 359.
Note:
The coax interface must be disconnected from the
attachment card.
TD 38 FRU 7 38 (*) The twinax interface must have the self-terminating
cable (PN 38F8254) connected.
Notes:
X Can be any number.
(*) This error message will display if a loop-back connector is not installed. Press the Form
Feed key to bypass this test. If a loop-back connector is installed, perform the
recommended action.
(**) This error can occur in any test that requires a mechanical operation; T&D 11, 12, 14, 15,
16, 17, or 18.
(***) This error can be: 00, 30, 31, 32, 33, 34, 35, 36, 37, 38
Chapter 2. Diagnostics
239
To Next Page
Loading...
