v The paper load lever is located on the right side of each bin when viewed from the rear of the printer. See
Figure 1.
v The paper load lever is closed when it is pushed as far toward the front of the printer as possible.
5. Ensure that the paper guide on each side of each bin is correctly adjusted:
v Standing behind the printer, set the inside edge of the right paper guide to the scribe mark and use the
paper guide locking lever to lock the position. See Figure 1.
v Set the left paper guide to touch the left edge of the forms in the bin. Use the left paper guide locking lever
to lock the position.
6. On bin 1 only, ensure that the left and right forms selector levers are set correctly:
v Slide both selectors toward the printer to feed envelopes or card stock. See Figure 1.
v Slide both selectors away from the printer to feed single sheets of paper.
Note: Some multiple-part forms may feed better with the forms selector levers set toward the printer. You
must test the forms in both positions.
Forms Selector Levers
Paper Load Lever
Left Paper Guide
Locking Lever
Left Paper Guide
Figure 1. ASF Paper Load Levers, Paper Guides, and Forms Selectors.
The length of this attachment card is
approximately 248 mm (9.7 in.).
Chapter 1. Diagnosing Problems 27
To Next Page
Loading...
Need help?
General