Table 11. MAP 0150: Power Supply (continued)
Questions/Actions Yes No
11. a. Power off (O) the printer.
b. Connect the printhead cable connector(s).
c. Power on (|) the printer.
Does the power supply fan run OK?
Go to step 12. Power off (O) the printer.
Install new printhead cables. – or –
Install a new printhead. Carefully follow
the replacement procedure, “Printhead”
on page 356.
Run T&D in automatic mode to verify
correct printer operation. For Model
A00, see “How To Run the Test and
Diagnostic (T&D) Programs” on
page 161. For Models 001, 002, or 003,
see “How To Run the Test and
Diagnostic (T&D) Programs” on
page 201.
12. a. Power off (O) the printer.
b. Connect the stacker cable connector.
c. Power on (|) the printer.
Does the power supply fan run OK?
Go to step 13 on page 84. Power off (O) the printer.
Install a new stacker cable.
Run T&D in automatic mode to verify
correct printer operation. For Model
A00, see “How To Run the Test and
Diagnostic (T&D) Programs” on
page 161. For Models 001, 002, or 003,
see “How To Run the Test and
Diagnostic (T&D) Programs” on
page 201.
Chapter 1. Diagnosing Problems
83
To Next Page
Loading...
