IBM SAN Volume Controller 2145-CG8 - Boot-Disk SAS Cable Routed through the Blue Bulkhead Clip and Connected to the SAS Disk Controller in the SAN Volume Controller 2145-CG8 or 2145-CF8

1 Boot-disk SAS cable that is plugged into the disk-controller-and-USB-riser-card assembly
2 Blue bulkhead clip with the high-speed SAS-adapter cable and the boot-disk SAS cable
Remove the boot-disk SAS cable from the blue bulkhead clip if necessary, before removing the
high-speed SAS adapter cable from the clip.
11. Disconnect the high-speed SAS cable from the SAS connector in the center of the back of the disk
backplane, as shown in Figure 200 on page 204.
21
Figure 199. Boot-disk SAS cable routed through the blue bulkhead clip and connected to the SAS disk controller in the
SAN Volume Controller 2145-CG8 or 2145-CF8
Chapter 2. Removing and replacing parts 203
|
|
|
|
|
|
|
|
|
|
|
|