EN
6 - USE AND OPERATION Master 80 UP HyperFlexible
6 - Pag. 2 / 2
6.1 CONTROL DESCRIPTION
INFORMATION:
From the hand-held keyboard it is possible to automatically start the bar feeder,
even when the Lathe ‘MAN/AUT' signal is in Manual mode.
INFORMATION:
When the bar feeder is in Automatic mode, the bar feeding is possible only when
the Lathe "MAN/AUT" signal is in Automatic mode.
INFORMATION:
By pressing the Manual mode button on the handheld keyboard it is possible to
prevent the bar feeder Automatic start by the lathe.
To Next Page
Loading...
