IEMCA Master 80 UP HyperFlexible - Operating Cycle General Description; Operating Cycle

EN
2 - TECHNICAL INFORMATION Master 80 UP HyperFlexible
2 - Pag. 10 / 10
2.2 OPERATING CYCLE - GENERAL DESCRIPTION
2.2.1 OPERATING CYCLE
The automatic mode controls the movements of the bar feeder according to the sequence
described below.
- The bar pusher (A) makes bar (B) move forwards into the lathe until the bars are finished.
The bar pusher (A), during the machining phase, in fixed points (see operation manual
Par.80), activates the locking devices to increase rigidity of the bar pusher and decrease
vibrations.
The bar pusher (A) and remnant (C) are in their forwards limit stop position.