IEMCA Master 80 UP HyperFlexible - Automatic Cycle Start

6 - USE AND OPERATION Master 80 UP HyperFlexible
EN
6 - Pag. 17 / 17
6.8 AUTOMATIC CYCLE START
• Power on the lathe.
• Turn the main switch to position I (ON).
• Press
to start the bar feeder.
• Press to select the manual mode.
• Carry out a "bar feeder zero setting" in the following way:
-press the start buttons and
;
INFORMATION:
The zero axis can be performed with open or closed guide channels.
Before performing the zero axis, make sure the bar pusher is not in the "back
limit stop" position.
• Load one bar in the guide channels and start the automatic cycle.