IEMCA Master 80 UP HyperFlexible - Elevator Carriage Drive Adjustment; Elevator Carriages Setup

5 - ADJUSTMENT AND SETUP Master 80 UP HyperFlexible
EN
5 - Pag. 21 / 21
5.4.2 Elevator carriage drive - Adjustment
The safety joint has to be adjusted so that the bar
is lifted and, at the same time, the motor drive is
deactivated when the bar cannot be lifted for
whatever reason.
Adjust as follows:
• Loosen screw (A);
• tighten or loosen ring nut (B);
• tighten screw (A).
WARNING - CAUTION:
do not screw the ring nut too much; the
joint could be locked.
5.4.3 Elevator carriages - Setup
Adjust the position of the bar gripping lever (A)
according to the bar diameter and section.
Adjust as follows:
• bring the elevator carriages at about half-stroke
by means of selector switch (B) to make the
operation easier;
• tighten or loosen screw (C).