EN
11 - COLLETS Master 80 UP HyperFlexible
11 - Pag. 26 / 26
11.18 EJECTORS 602P..011
11.19 EJECTORS - Guide channels ø13 28 - Table
WARNING - CAUTION:
the external diameter of the ejector must be at least 0.5 mm less than the
external diameter of the bar pusher.
INFORMATION:
upon specific request, non standard collets with reduced thickness (which are
not mentioned in this table) may be supplied as well. Their durability is however
below the durability of standard collets.
A Ejector
To Next Page
Loading...
