IEMCA Master 80 UP HyperFlexible - 381 P..011 Ejectors Guide Channels ø52÷86 Table

EN
11 - COLLETS Master 80 UP HyperFlexible
11 - Pag. 36 / 36
11.26 381P..011 EJECTORS - Guide channels ø52 86 - Table
WARNING - CAUTION:
the external diameter of the ejector must be at least 0.5 mm less than the
external diameter of the bar pusher.
INFORMATION:
upon specific request, non standard collets with reduced thickness (which are
not mentioned in this table) may be supplied as well. Their durability is however
below the durability of standard collets.
CH4: T Allen wrench - DIN 911
A Ejector