IEMCA Master 80 UP HyperFlexible - Ejectors 381 P..011 - 381 P..021; 381 P..021 Ejectors Guide Channels ø33÷46 Table

EN
11 - COLLETS Master 80 UP HyperFlexible
11 - Pag. 34 / 34
11.24 EJECTORS 381P..011 - 381P..021
11.25 381P..021 EJECTORS - Guide channels ø33 46 - Table
WARNING - CAUTION:
the external diameter of the ejector must be at least 0.5 mm less than the
external diameter of the bar pusher.
INFORMATION:
upon specific request, non standard collets with reduced thickness (which are
not mentioned in this table) may be supplied as well. Their durability is however
below the durability of standard collets.
CH4: T Allen wrench - DIN 911
A Ejector