4 - HANDLING AND INSTALLATION Master 80 UP HyperFlexible
EN
4 - Pag. 11 / 11
4.4.5 Levelling and alignment
FOREWORD
The alignment between the bar feeder and lathe is the most critical phase; therefore, this
operation should be carried out with the greatest accuracy by experienced personnel.
WARNING - CAUTION:
an error during the alignment may be the major cause of a bad operation of the
bar feeder and of its consequent damage.
PRELIMINARY PROCEDURE
• Open the upper guard.
• To bring the bar pusher to its backward limit
stop, press the
or button in manual
mode on the handheld keyboard.
To Next Page
Loading...
