11 - COLLETS Master 80 UP HyperFlexible
EN
11 - Pag. 23 / 23
11.16 BORING COLLETS FOR BARS 601P
11.17 BORING COLLETS FOR SQUARE AND HEXAGONAL BARS - Table
WARNING - CAUTION:
The bar minimum diameter that allows its machining is in any case the one
indicated in the table "Guide channel, bar pusher, bar and pipe diameters" in
section 2.6.
INFORMATION:
to determine the internal diameter øA, do not refer to file "001 - Conversion
Tables", but refer directly to the table below.
INFORMATION:
upon specific request, non standard collets with reduced thickness (which are
not mentioned in this table) may be supplied as well. Their durability is however
below the durability of standard collets.
Code structure
A Collet
B Bar diameter
C Example:
3 mm = 030
3.5 mm = 035
12.5 mm = 125
12.75 mm = 127
D Category
To Next Page
Loading...
