IEMCA Master 80 UP HyperFlexible - PLC Battery Replacement

EN
9 - PART REPLACEMENT Master 80 UP HyperFlexible
9 - Pag. 4 / 4
9.4 PLC BATTERY – REPLACEMENT
Replace the battery every year, or when the following message is displayed: "PLC battery
exhausted"
INFORMATION:
when this message is displayed, the battery
should be replaced within one day,
otherwise, the "PLC/NC Software" data will
be deleted.
• unscrew plug (A) and remove battery (B);
• insert a new battery (3.6 volts lithium AA battery) and
make sure that it is introduced correctly, then tighten the
plug (A).
PLC battery exhausted