EasyManua.ls Logo

IEMCA Master 80 UP HyperFlexible - Backing Plates and Support Feet Installation

IEMCA Master 80 UP HyperFlexible
190 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
4 - HANDLING AND INSTALLATION Master 80 UP HyperFlexible
4 - Pag. 6 / 6
4.4.1 Backing plates and support feet - Installation
• Position the bar feeder next to the lathe.
• Lift it and install the plates in the positions
shown in the figure.

Table of Contents

Related product manuals