IEMCA Master 80 UP HyperFlexible - Ejector 336; Ejector Guide Channels ø<30 Table

11 - COLLETS Master 80 UP HyperFlexible
EN
11 - Pag. 17 / 17
11.11 EJECTOR 336
11.12 EJECTOR – Guide channels ø<30 - Table
WARNING - CAUTION:
the external diameter of the ejector must be at least 0.5 mm less than the
external diameter of the bar pusher.
INFORMATION:
upon specific request, non standard collets with reduced thickness (which are
not mentioned in this table) may be supplied as well. Their durability is however
below the durability of standard collets.
CH*: double-ended fork wrench DIN3110
A Ejector