IEMCA Master 80 UP HyperFlexible - Page 121

6 - USE AND OPERATION Master 80 UP HyperFlexible
EN
6 - Pag. 19 / 19
INFORMATION:
the bar drop control devices will not go up if, during the "GUIDE CHANNEL FULL
OPENING" phase there is a bar in the guide channels that has prevented the
short feed gate resetting.
Press
to cause the bar to drop
from the magazine and
appoggiare agli
accompagnatori
Press
(Phase “ BAR LOADING ”)
Press
(Phase “ BAR FIRST
FEEDING ”)
Press
(Phase “ CARRIAGE
RETURN ”)
SEMIAUTOMATIC
procedure
Press
(Phase “ GUIDE AND CLAMP
FULL CLOSING ”)
Press
(Phase “ BAR INTRO.
INTO COLLET ”)
Press
(Phase “ CLAMP WORKING
POSITION ”)
Press
(Phase “ FACING ”)