EN
3 - SAFETY - GENERAL INFORMATION Master 80 UP HyperFlexible
3 - Pag. 12 / 12
1)The colour loses intensity.
2)Other pieces of equipment or panels placed too close to the warning lamps on the bar feeder.
THERE ARE CIRCUITS NOT INTERRUPTED BY THE DISCONNECTING DEVICE
- There is danger caused by voltages from the lathe signals that are not interrupted by
disconnectors in the bar feeder.
During installation, check if it is possible to disconnect the system upstream from the bar feeder
using protection devices.
SEQUENCE OF PHASES
- It is very important that the operator knows the sequence of the bar feeder work phases.
These can be found in the Instruction Manual supplied with the machine.
DIFFERENTIAL CURRENT DEVICE UPSTREAM FROM THE MACHINE, USED TO PREVENT
HAZARDOUS CONDITIONS IN CASE OF A FAILURE
- Make sure that the bar feeder is powered by a three-phase power supply protected
through a differential switch with interrupting power (for example, of 30 mA).
RULES FOR ELECTRIC POWER SUPPLY
- Before performing the electrical connection of the bar feeder, check that the three-phase
power supply voltage that reaches it matches what is indicated on the identification plate
located on the electrical control panel door.
To Next Page
Loading...
