IEMCA Master 80 UP HyperFlexible - Page 7

INDEX
5.3.1 Guide channels, half bushes, bar pusher and collet - Replacement .............................. 5
5.3.2 BAR PUSHER REPLACEMENT PROCEDURE ................................................................. 14
5.3.3 Remnant passage door spring - Adjustment .................................................................. 15
5.3.4 REMNANT DROP CHUTE – ENABLING
.................................................................... 16
5.4 MAGAZINE SETUP
...................................................................................................... 17
5.4.1 Bar supporting bracket - Setup ........................................................................................ 17
5.4.2 Elevator carriage drive - Adjustment ............................................................................... 20
5.4.3 Elevator carriages - Setup ................................................................................................. 20
6 USE AND OPERATION Master 80 UP HyperFlexible ....................................................... 1
6.1 CONTROL DESCRIPTION .................................................................................................... 2
6.2 KEYBOARD CONTROL DESCRIPTION .............................................................................. 5
6.3 MAGAZINE PUSH-BUTTON PANEL - CONTROL DESCRIPTION ..................................... 9
6.4 LIGHT INDICATOR - SIGNAL DESCRIPTION ................................................................... 10
6.5 BAR FEEDER TOOLING .................................................................................................... 11
6.6 BARS TO BE MACHINED - FEATURES AND PREPARATION ........................................ 11
6.6.1 BAR STRAIGHTNESS - Measurement .............................................................................. 13
6.7 BAR MAGAZINE - LOADING .............................................................................................. 15
6.8 AUTOMATIC CYCLE START.............................................................................................. 17
6.9 BAR LOADING - PROCEDURE .......................................................................................... 18
6.10 LUBRICATING OIL - FLOW ADJUSTMENT ...................................................................... 21
6.11 BAR FEEDER STOP ........................................................................................................... 21
6.12 CYCLE PERFORMING MODE IN THE "STEP-BY-STEP" FUNCTION ............................. 22
7 BAR FEEDER MAINTENANCE Master 80 UP HyperFlexible .......................................... 1
7.1 MAINTENANCE – GENERAL RULES
........................................................................... 2
7.2 SCHEDULED MAINTENANCE
...................................................................................... 3
7.2.1 Lubricating oil - Level check ............................................................................................... 4
7.2.2 Lubricating oil - Change ...................................................................................................... 5
7.2.3 Oil filter - Cleaning ............................................................................................................... 6
7.2.4 Air filter unit - Check ............................................................................................................ 7
7.3 LUBRICATION POINT DIAGRAM
................................................................................. 8